How To Put Curtain Rods Up

Slip all the curtain rings onto the rod and place the rod on the holders. Use a rubber mallet to tap in the drywall anchors.

How To Hang Curtain Rods How Tos Diy

Any curtain rod can fit into the rod holder with much ease.

How to put curtain rods up. Cover the screw holes with timber plugs to finish the job. There are instant-up Rod Holders that wrap around the upper corners of the window molding. Buy two sets of matching curtain rods and also get a joining splice.

At this point youll want to put the curtains on the rod and then attach the finials before you put the rod up. Step 4 Set the curtain rod onto the hooks centering the rod between the two hooks and arrange the curtain over the window. Align the bracket over the center of the 15â mark referenced in step 2 and use a pencil to mark the holes where the screws will go.

Tension the line enough so that the line supports much of the weight of the curtains. Unlock the curtain rod ends and get a friend to help you extend both sides of the rod. DIY Curtain Rod.

Push the rod through your curtain if the curtain has eye-holes. Put the shower curtain rings onto the rod before installation. If using rings put them in place on the rod now.

Attach the joining splice to the open end of one of the rods then insert the open end of the second rod. Draw the curtains and let them sit for 1 hour to make sure the adhesive hooks can hold the weight. As a general rule drapes will be open during the day so make sure the curtain rod extends at least four inches on each side of the windows inside frame.

Install the curtain onto the curtain rod. Finally screw some small screws through the holders into the rod to stop the rod from slipping sideways. Screw the stop end onto the left end of the rod.

Dont forget to attach center brackets when putting up your rods as extra long curtain rods often need help staying up. Shop on Home Depot. Depending on how large your window is youll need repeat all of the above steps for one or two more brackets.

Install a bracket or hook above the center of the rod on the wall or on the ceiling and connect it to the rod. It can firmly hold because a V-shaped piece slides between the frame and the wall to make it firm. Ensure that the weight of the curtain will not exceed the combined weight limit of two hooks--probably between 5 and 10 lbs.

All you need to do is hang a hook on either side of the window and pop a rod it and youre done. The Instant-up rod holders come with a screw hole on either side in case you want to attach. Place the rod into the right side bracket and use a level to determine the placement of the left side bracket.

Use a small eye screw in the ceiling and use fish line to tie the rod to the screw for a decent solution that is. The standard distance from the window casing to the end of the curtain rod excluding finials on each side of the window should be four to 10 inches. Run the curtain rod through the hoops at the top of your curtains and then hang it up again.

Step 4 Bring the tension rod with the rings on it up to the height you marked on the wall and place the first side in the correct position. Youll need to get the curtain on the rod before you hang it unless youre using rings. Similar to stick on curtain rods Command hooks are another answer to how to hang curtains without drilling into the wall.

String your curtain on the curtain rod and hang it up. Then screw in the stop end for the right end of the rod. In fact they even make some specifically for this purpose.

One simple and stealthy design. Remove the finial from one end of both rods.

How To Fit Curtain Poles Free Advice From Fabric Gallery Interiors